Re: [PATCH v2 0/2] MCAN: Add support for implementing transceiver as a phy

[Marc Kleine-Budde]

On 15.04.2021 21:16:33, Aswath Govindraju wrote:
> The following series of patches add support for implementing the
> transceiver as a phy of m_can_platform driver.
> 
> TCAN1042 has a standby signal that needs to be pulled high for
> sending/receiving messages[1]. TCAN1043 has a enable signal along with
> standby signal that needs to be pulled up for sending/receiving
> messages[2], and other combinations of the two lines can be used to put the
> transceiver in different states to reduce power consumption. On boards
> like the AM654-idk and J721e-evm these signals are controlled using gpios.
> 
> These gpios are set in phy driver, and the transceiver can be put in
> different states using phy API. The phy driver is added in the series [3].
> 
> This patch series is dependent on [4].

Looks good. Can you ping me after the next -rc1, when this patch hits
mainline. Then I'll merge this into linux-can-next.

regards,
Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde           |
Embedded Linux                   | https://www.pengutronix.de  |
Vertretung West/Dortmund         | Phone: +49-231-2826-924     |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-5555 |

Attachment: signature.asc
Description: PGP signature