Re: [PATCH] Input: ili210x - Set the device name according to the device model

[Marek Vasut]

On 9/1/21 9:22 PM, Rogerio Pimentel wrote:

[...]

> diff --git a/drivers/input/touchscreen/ili210x.c b/drivers/input/touchscreen/ili210x.c
> index 30576a5f2f04..ca7af4a6f588 100644
> --- a/drivers/input/touchscreen/ili210x.c
> +++ b/drivers/input/touchscreen/ili210x.c
> @@ -19,6 +19,8 @@
>   #define ILI251X_DATA_SIZE1	31
>   #define ILI251X_DATA_SIZE2	20
>   
> +#define ILI_NAME_LEN		27
> +
>   /* Touchscreen commands */
>   #define REG_TOUCHDATA		0x10
>   #define REG_PANEL_INFO		0x20
> @@ -394,6 +396,7 @@ static int ili210x_i2c_probe(struct i2c_client *client,
>   	struct input_dev *input;
>   	int error;
>   	unsigned int max_xy;
> +	char *model_name;
>   
>   	dev_dbg(dev, "Probing for ILI210X I2C Touschreen driver");
>   
> @@ -440,7 +443,11 @@ static int ili210x_i2c_probe(struct i2c_client *client,
>   	i2c_set_clientdata(client, priv);
>   
>   	/* Setup input device */
> -	input->name = "ILI210x Touchscreen";
> +	input->name = "Ilitek         Touchscreen";
> +	model_name = (char *)input->name;
> +	snprintf(model_name, ILI_NAME_LEN, "Ilitek %s Touchscreen",

Which ilitek devices do you have available exactly ?

There is a firmware interface which does report the device type, but I 
don't know whether it works on all the ilitek touchscreen devices. If it 
does, then it could be used here to pull the type from the firmware and 
then use this instead

snprintf(model_name, ILI_NAME_LEN, "Ilitek ILI%04x Touchscreen", type);

Try this command against the touch controller, it sends it command 0x61 
and reads two bytes of the reply:
i2ctransfer -f -y 1 w1@0x41 0x61 r2
0x10 0x25 # <---- on ILI2510 it reports 0x25 0x10 in reverse