[PATCH RFC 0/3] add Vertexcom MSE102x support

[Stefan Wahren]

This patch series adds support for the Vertexcom MSE102x Homeplug GreenPHY
chips [1]. They can be connected either via RGMII, RMII or SPI to a host CPU.
These patches handles only the last one, with an Ethernet over SPI protocol
driver.

The code has been tested only on Raspberry Pi boards, but should work
on other platforms.

Any comments about the code are welcome.

[1] - http://www.vertexcom.com/p_homeplug_plc_en.html

Stefan Wahren (3):
  dt-bindings: add vendor Vertexcom
  dt-bindings: net: add Vertexcom MSE102x support
  net: vertexcom: Add MSE102x SPI support

 .../bindings/net/vertexcom-mse102x.yaml       |  71 ++
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 drivers/net/ethernet/Kconfig                  |   1 +
 drivers/net/ethernet/Makefile                 |   1 +
 drivers/net/ethernet/vertexcom/Kconfig        |  25 +
 drivers/net/ethernet/vertexcom/Makefile       |   6 +
 drivers/net/ethernet/vertexcom/mse102x.c      | 803 ++++++++++++++++++
 7 files changed, 909 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/vertexcom-mse102x.yaml
 create mode 100644 drivers/net/ethernet/vertexcom/Kconfig
 create mode 100644 drivers/net/ethernet/vertexcom/Makefile
 create mode 100644 drivers/net/ethernet/vertexcom/mse102x.c

-- 
2.17.1