Re: [PATCH v3 0/2] Use "ref" clocks from firmware for DSI PLL VCO parent

[Stephen Boyd]

Quoting Marijn Suijten (2021-09-11 06:19:19)
> All DSI PHY/PLL drivers were referencing their VCO parent clock by a
> global name, most of which don't exist or have been renamed.  These
> clock drivers seem to function fine without that except the 14nm driver
> for sdm6xx [1].
> 
> At the same time all DTs provide a "ref" clock as per the requirements
> of dsi-phy-common.yaml, but the clock is never used.  This patchset puts
> that clock to use without relying on a global clock name, so that all
> dependencies are explicitly defined in DT (the firmware) in the end.

I can take this through clk tree if it helps avoid conflicts. There are
some other patches to sdm660.c in the clk tree already.