Re: [PATCH] ARM: dts: stm32: fix stusb1600 pinctrl used on stm32mp157c-dk

[Alexandre TORGUE]

Hi Fabrice

On 11/26/21 12:33 PM, Fabrice Gasnier wrote:
> A pinctrl handle is used to setup a pull-up on the stusb1600 IRQ pin (that
> is open drain).
> When in ANALOG state, no pull-up can be applied in the GPIO HW controller,
> still the setting is done into the register. The pull-up is effective
> currently, only when the GPIO IRQ is requested. The correct setting is to
> use directly the GPIO, instead of ANALOG state.
>
> Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxxxxxxx>
> ---
>   arch/arm/boot/dts/stm32mp15-pinctrl.dtsi | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
> index 5f060fe..3b65130 100644
> --- a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
> @@ -1718,7 +1718,7 @@
>   
>   	stusb1600_pins_a: stusb1600-0 {
>   		pins {
> -			pinmux = <STM32_PINMUX('I', 11, ANALOG)>;
> +			pinmux = <STM32_PINMUX('I', 11, GPIO)>;
>   			bias-pull-up;
>   		};
>   	};

Applied on stm32-next

Regards
Alex