Re: [PATCH v2 2/2] irqchip: Add Qualcomm MPM controller driver

[Shawn Guo]

On Tue, Nov 30, 2021 at 02:34:28PM +0530, Maulik Shah wrote:
> Hi,
> 
> On 11/30/2021 2:14 PM, Shawn Guo wrote:
> > On Tue, Nov 30, 2021 at 01:56:02PM +0530, Maulik Shah wrote:
> > > Hi,
> > > 
> > > On 11/29/2021 7:15 PM, Shawn Guo wrote:
> > > > > This is not limited to suspend, you will need to notify RPM during deepest
> > > > > cpu idle state entry as well, since MPM may be monitoring interrupts in that
> > > > > case too.
> > > > Yeah, I was trying to test this MPM driver with cpuidle, but failed to
> > > > see the SoC get into vlow/vmin state from cpuidle.
> > > In a few cases SoC can enter vmin/vlow from cpuidle one is from static
> > > screen on.
> > > 
> > > > Do you have any
> > > > suggestion how I should test it properly?
> > > Suspend resume (use "s2idle" and not "deep" mode on upstream kernel) is one
> > > good method, but you will have to make sure all drivers have removed votes
> > > on xo clock when entering suspend.
> > > Also need to make sure other subsystem like modem is in power collaspe (look
> > > at the internal master stats driver to know if other subsystems entering to
> > > low power mode or not).
> > I have already been able to trigger a vmin sleep with s2idle by doing:
> > 
> >   $ echo mem > /sys/power/state
> > 
> > My question is how I can get a vmin sleep in idle case, so that MPM
> > driver can be tested in both suspend and idle context.
> > 
> > Shawn
> 
> In a few cases SoC can enter vmin/vlow from cpuidle one is from static screen on.
> you can turn on display and set display off timeout to maximum (30 minutes) in android phone and then just leave the device idle for few minutes
> 
> another possible way (if display is not present) is to take some wake_lock (write something to /sys/power/wake_lock) and disconnect USB and leave the device idle for few minutes.
> since taking wake_lock device will not enter suspend, cpuidle can make SoC enter deepest mode like vmin (if all other conditions like other subsystem sleeping and votes on xo clock removed, etc met).

I'm running an upstream kernel with neither display nor USB enabled.  I
will test again and check conditions of other subsystems.

Thanks for the input, Maulik!

Shawn