[PATCH] serial: imx: leave IRTS disabled if using modem-control CTS

[Tim Harvey]

If using modem-control gpios for CTS we must leave IRTS disabled
as otherwise the hardware will only transmit based on the internal RTS
pin routed to it.

This allows hardware flow control to be used with cts-gpios.

Signed-off-by: Tim Harvey <tharvey@xxxxxxxxxxxxx>
---
 drivers/tty/serial/imx.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index df8a0c8b8b29..bf2bb987a51f 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -201,6 +201,7 @@ struct imx_port {
 	unsigned int		old_status;
 	unsigned int		have_rtscts:1;
 	unsigned int		have_rtsgpio:1;
+	unsigned int		have_ctsgpio:1;
 	unsigned int		dte_mode:1;
 	unsigned int		inverted_tx:1;
 	unsigned int		inverted_rx:1;
@@ -1674,8 +1675,7 @@ imx_uart_set_termios(struct uart_port *port, struct ktermios *termios,
 		if (ucr2 & UCR2_CTS)
 			ucr2 |= UCR2_CTSC;
 	}
-
-	if (termios->c_cflag & CRTSCTS)
+	if (!sport->have_ctsgpio && termios->c_cflag & CRTSCTS)
 		ucr2 &= ~UCR2_IRTS;
 	if (termios->c_cflag & CSTOPB)
 		ucr2 |= UCR2_STPB;
@@ -2227,6 +2227,9 @@ static int imx_uart_probe(struct platform_device *pdev)
 	if (of_get_property(np, "fsl,dte-mode", NULL))
 		sport->dte_mode = 1;
 
+	if (of_get_property(np, "cts-gpios", NULL))
+		sport->have_ctsgpio = 1;
+
 	if (of_get_property(np, "rts-gpios", NULL))
 		sport->have_rtsgpio = 1;
 
-- 
2.17.1