[PATCH v3 0/9] arm64: dts: qcom: sa8775p-ride: enable relevant QUPv3 IPs

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>

This enables the QUPv3 interfaces that are exposed on the sa8775p-ride
board: I2C, SPI and the Bluetooth and GNSS UART ports.

v2 -> v3:
- fix the interrupt number for uart12
- replace underscores with hyphens in DT node names (although make dtbs_check
  does not raise warnings about this)
- rearrange the commits so that they're more fine-grained with separate
  patches for adding nodes to dtsi and enabling them for the board

v1 -> v2:
- uart17 is the Bluetooth port, not GNSS
- add uart12 for GNSS too in that case

Bartosz Golaszewski (9):
  arm64: dts: qcom: sa8775p: add the QUPv3 #2 node
  arm64: dts: qcom: sa8775p-ride: enable QUPv3 #2
  arm64: dts: qcom: sa8775p: add the i2c18 node
  arm64: dts: qcom: sa8775p-ride: enable i2c18
  arm64: dts: qcom: sa8775p: add the spi16 node
  arm64: dts: qcom: sa8775p-ride: enable the SPI node
  arm64: dts: qcom: sa8775p: add high-speed UART nodes
  arm64: dts: qcom: sa8775p-ride: enable the GNSS UART port
  arm64: dts: qcom: sa8775p-ride: enable the BT UART port

 arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 100 ++++++++++++++++++++++
 arch/arm64/boot/dts/qcom/sa8775p.dtsi     |  86 +++++++++++++++++++
 2 files changed, 186 insertions(+)

-- 
2.37.2