Re: [PATCH] serial: 8250_fintek: Add using BIOS IRQ default setting

[Greg KH]

On Fri, Feb 17, 2023 at 04:49:53PM +0800, Ji-Ze Hong (Peter Hong) wrote:
> In 8250_fintek.c probe_setup_port(), we'll detect the IRQ trigger mode by
> irq_get_irq_data() and pass it to fintek_8250_set_irq_mode(). If detected
> Edge mode, we'll set the UART with Edge/High mode, otherwise Level/Low.
> 
> But in some motherboard, The APIC maybe setting to Level/High. In this case
> the driver will setting wrong configuration into UART. So we add a option
> to kernel parameter to control the driver as following:
> 
> 	fintek_uart_irq_mode_override= [SERIAL]
> 		{default, bios}
> 		If the parameter is "default", the driver will using
> 		former IRQ override methed(By IRQ trigger type).
> 		otherwise, we'll don't change the UART IRQ setting.
> 
> Signed-off-by: Ji-Ze Hong (Peter Hong) <hpeter+linux_kernel@xxxxxxxxx>

Also note, your From: line does not match this line, so I couldn't take
this patch anyway :(

And why are you sending patches through a random gmail account and not
your fintek.com.tw address?  Please use that one, so that we can easily
verify that this is coming from the proper address and no one is
impersonating you.

thanks,

greg k-h