Re: [PATCH v4 3/3] gpio: ws16c48: Migrate to the regmap API

[Michael Walle]

> The regmap API supports IO port accessors so we can take advantage of
> regmap abstractions rather than handling access to the device registers
> directly in the driver.
> 
> The WinSystems WS16C48 provides the following registers:
> 
>     Offset 0x0-0x5: Port 0-5 I/O
>     Offset 0x6: Int_Pending
>     Offset 0x7: Page/Lock
>     Offset 0x8-0xA (Page 1): Pol_0-Pol_2
>     Offset 0x8-0xA (Page 2): Enab_0-Enab_2
>     Offset 0x8-0xA (Page 3): Int_ID0-Int_ID2
> 
> Port 0-5 I/O provides access to 48 lines of digital I/O across six
> registers, each bit position corresponding to the respective line.
> Writing a 1 to a respective bit position causes that output pin to sink
> current, while writing a 0 to the same bit position causes that output
> pin to go to a high-impedance state and allows it to be used an input.
> Reads on a port report the inverted state (0 = high, 1 = low) of an I/O
> pin when used in input mode. Interrupts are supported on Port 0-2.
> 
> Int_Pending is a read-only register that reports the combined state of
> the INT_ID0 through INT_ID2 registers; an interrupt pending is indicated
> when any of the low three bits are set.
> 
> The Page/Lock register provides the following bits:
> 
>     Bit 0-5: Port 0-5 I/O Lock
>     Bit 6-7: Page 0-3 Selection
> 
> For Bits 0-5, writing a 1 to a respective bit position locks the output
> state of the corresponding I/O port. Writing the page number to Bits 6-7
> selects that respective register page for use.
> 
> Pol_0-Pol_2 are accessible when Page 1 is selected. Writing a 1 to a
> respective bit position selects the rising edge detection interrupts for
> that input line, while writing a 0 to the same bit position selects the
> falling edge detection interrupts.
> 
> Enab_0-Enab_2 are accessible when Page 2 is selected. Writing a 1 to a
> respective bit position enables interrupts for that input line, while
> writing a 0 to that same bit position clears and disables interrupts for
> that input line.
> 
> Int_ID0-Int_ID2 are accessible when Page 3 is selected. A respective bit
> when read as a 1 indicates that an edge of the polarity set in the
> corresponding polarity register was detected for the corresponding input
> line. Writing any value to this register clears all pending interrupts
> for the register.
> 
> Cc: Paul Demetrotion <pdemetrotion@xxxxxxxxxxxxxx>
> Suggested-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
> Signed-off-by: William Breathitt Gray <william.gray@xxxxxxxxxx>

Same here, gpio-regmap part looks good:

Reviewed-by: Michael Walle <michael@xxxxxxxx>

-michael