[PATCH] dt-bindings: power: supply: bq256xx: Add ts-ignore property

[Hermes Zhang]

Add a new property: ts-ignore to allow user to enable the TS_IGNORE flag
in chip. Ignore TS pin will allow user to control the charging
parameters instead of the default JEITA profile in chip.

Signed-off-by: Hermes Zhang <chenhuiz@xxxxxxxx>
---
 Documentation/devicetree/bindings/power/supply/bq256xx.yaml | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/power/supply/bq256xx.yaml b/Documentation/devicetree/bindings/power/supply/bq256xx.yaml
index 82f382a7ffb3..74fd48f4bec5 100644
--- a/Documentation/devicetree/bindings/power/supply/bq256xx.yaml
+++ b/Documentation/devicetree/bindings/power/supply/bq256xx.yaml
@@ -68,6 +68,12 @@ properties:
       Interrupt sends an active low, 256 μs pulse to host to report the charger
       device status and faults.
 
+  ts-ignore:
+    type: boolean
+    description: |
+      If this property is set, the TS_IGNORE flag will be set to 1 which means
+      will not apply JEITA profile during the charging.
+
 required:
   - compatible
   - reg
-- 
2.30.2