[PATCH v2 16/23] arm64: dts: colibri-imx8x: Add no-1-8-v to sd-card

[Philippe Schenker]

From: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>

Many Colibri carrier boards are using 3.3V pull-up resistors on the
SD-Card connector. Letting it switch to 1.8V is an invalid state.

Do prevent this from happening by keeping the signaling voltage at 3.3V.

Signed-off-by: Philippe Schenker <philippe.schenker@xxxxxxxxxxx>
---

(no changes since v1)

 arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi b/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
index 61033b79e44e..2e228c5b8109 100644
--- a/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
@@ -304,6 +304,7 @@ &usdhc2 {
 	pinctrl-2 = <&pinctrl_usdhc2_200mhz>, <&pinctrl_usdhc2_gpio>;
 	pinctrl-3 = <&pinctrl_usdhc2_sleep>, <&pinctrl_usdhc2_gpio_sleep>;
 	disable-wp;
+	no-1-8-v;
 };
 
 &iomuxc {
-- 
2.39.2