Re: [PATCH v4 6/9] dt-bindings: sc16is7xx: Add property to change GPIO function

[Conor Dooley]

On Mon, May 29, 2023 at 10:07:08AM -0400, Hugo Villeneuve wrote:
> From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
> 
> Some variants in this series of UART controllers have GPIO pins that
> are shared between GPIO and modem control lines.
> 
> The pin mux mode (GPIO or modem control lines) can be set for each
> ports (channels) supported by the variant.
> 
> This adds a property to the device tree to set the GPIO pin mux to
> modem control lines on selected ports if needed.
> 
> Signed-off-by: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
> ---
>  .../bindings/serial/nxp,sc16is7xx.txt         | 46 +++++++++++++++++++
>  1 file changed, 46 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
> index 0fa8e3e43bf8..74dfbbf7b2cb 100644
> --- a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
> +++ b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
> @@ -23,6 +23,9 @@ Optional properties:
>      1 = active low.
>  - irda-mode-ports: An array that lists the indices of the port that
>  		   should operate in IrDA mode.
> +- nxp,modem-control-line-ports: An array that lists the indices of the port that
> +				should have shared GPIO lines configured as
> +				modem control lines.
>  
>  Example:
>          sc16is750: sc16is750@51 {
> @@ -35,6 +38,26 @@ Example:
>                  #gpio-cells = <2>;
>          };
>  
> +	sc16is752: sc16is752@54 {
> +		compatible = "nxp,sc16is752";
> +		reg = <0x54>;
> +		clocks = <&clk20m>;
> +		interrupt-parent = <&gpio3>;
> +		interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
> +		nxp,modem-control-line-ports = <1>; /* Port 1 as modem control lines */
> +		gpio-controller; /* Port 0 as GPIOs */
> +		#gpio-cells = <2>;
> +	};
> +
> +	sc16is752: sc16is752@54 {
> +		compatible = "nxp,sc16is752";
> +		reg = <0x54>;

If this were not a txt binding, dt_binding_check would likely complain
that you have two nodes with the same node address & 3 below.
If you end up re-submitting, could you change that please?
Otherwise,
Acked-by: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>

Thanks,
Conor.

Attachment: signature.asc
Description: PGP signature