Re: [PATCH v2] gpio: 74x164: Enable output pins after registers are reset

[Bartosz Golaszewski]

On Thu, Feb 29, 2024 at 1:23 PM Arturas Moskvinas
<arturas.moskvinas@xxxxxxxxx> wrote:
>
>
>
> On 2/29/24 10:54, Bartosz Golaszewski wrote:
> > On Thu, Feb 29, 2024 at 9:47 AM Arturas Moskvinas
> > <arturas.moskvinas@xxxxxxxxx> wrote:
> >> Chip outputs are enabled[1] before actual reset is performed[2] which might
> >> cause pin output value to flip flop if previous pin value was set to 1 in chip.
> >> Change fixes that behavior by making sure chip is fully reset before all outputs
> >> are enabled.
> >>
> > Use imperative mood in commit messages - make it: "Fix that behavior
> > by making sure ...".
> Chip outputs are enabled[1] before actual reset is performed[2] which might
> cause pin output value to flip flop if previous pin value was set to 1
> in chip.
> Fix that behavior by making sure chip is fully reset before all outputs are
> enabled.
>
> Bartosz, does this look better?

.. if previous pin value was set to 1 period

Bart

>
> Arturas Moskvinas