Re: [RISC-V] [tech-j-ext] [RFC PATCH 5/9] riscv: Split per-CPU and per-thread envcfg bits

[Deepak Gupta]

On Tue, Mar 19, 2024 at 7:21 PM Samuel Holland
<samuel.holland@xxxxxxxxxx> wrote:
>
> >         else
> >                 regs->status |= SR_UXL_64;
> >  #endif
> > +       current->thread_info.envcfg = ENVCFG_BASE;
> >  }
> >
> > And instead of context switching in `_switch_to`,
> > In `entry.S` pick up `envcfg` from `thread_info` and write it into CSR.
>
> The immediate reason is that writing envcfg in ret_from_exception() adds cycles
> to every IRQ and system call exit, even though most of them will not change the
> envcfg value. This is especially the case when returning from an IRQ/exception
> back to S-mode, since envcfg has zero effect there.
>

A quick observation:
So I tried this on my setup. When I put `senvcfg` writes in
`__switch_to ` path, qemu suddenly
just tanks and takes a lot of time to boot up as opposed to when
`senvcfg` was in trap return path.
In my case entire userspace (all processes) have cfi enabled for them
via `senvcfg` and it gets
context switched. Not sure it's specific to my setup. I don't think it
should be an issue on actual
hardware.

Still debugging why it slows down my qemu drastically when same writes
to same CSR
are moved from `ret_from_exception` to `switch_to`