[PATCH net] net: micrel: Fix lan8841_config_intr after getting out of sleep mode

[Horatiu Vultur]

When the interrupt is enabled, the function lan8841_config_intr tries to
clear any pending interrupts by reading the interrupt status, then
checks the return value for errors and then continue to enable the
interrupt. It has been seen that once the system gets out of sleep mode,
the interrupt status has the value 0x400 meaning that the PHY detected
that the link was in low power. That is correct value but the problem is
that the check is wrong.  We try to check for errors but we return an
error also in this case which is not an error. Therefore fix this by
returning only when there is an error.

Fixes: a8f1a19d27ef ("net: micrel: Add support for lan8841 PHY")
Signed-off-by: Horatiu Vultur <horatiu.vultur@xxxxxxxxxxxxx>
---
 drivers/net/phy/micrel.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 13e30ea7eec5d..79477f0c90d82 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -4029,7 +4029,7 @@ static int lan8841_config_intr(struct phy_device *phydev)
 
 	if (phydev->interrupts == PHY_INTERRUPT_ENABLED) {
 		err = phy_read(phydev, LAN8814_INTS);
-		if (err)
+		if (err < 0)
 			return err;
 
 		/* Enable / disable interrupts. It is OK to enable PTP interrupt
-- 
2.34.1