Re: [PATCH 2/3] iio: light: opt3001: add support for TI's opt3002 light sensor

[Krzysztof Kozlowski]

On 05/09/2024 12:20, Emil Gedenryd wrote:
> TI's opt3002 light sensor shares most properties with the opt3001
> model, with the exception of supporting a wider spectrum range.
> 
> Add support for TI's opt3002 by extending the TI opt3001 driver.
> 
> See https://www.ti.com/product/OPT3002 for more information.
> 

...

>  
>  	mutex_init(&opt->lock);
>  	init_waitqueue_head(&opt->result_ready_queue);
> @@ -769,10 +892,18 @@ static int opt3001_probe(struct i2c_client *client)
>  		return ret;
>  
>  	iio->name = client->name;
> -	iio->channels = opt3001_channels;
> -	iio->num_channels = ARRAY_SIZE(opt3001_channels);
>  	iio->modes = INDIO_DIRECT_MODE;
>  	iio->info = &opt3001_info;
> +	switch (opt->chip_info->model) {
> +	case OPT3001:
> +		iio->channels = opt3001_channels;
> +		iio->num_channels = ARRAY_SIZE(opt3001_channels);
> +		break;
> +	case OPT3002:
> +		iio->channels = opt3002_channels;
> +		iio->num_channels = ARRAY_SIZE(opt3002_channels);
> +		break;
> +	}
>  
>  	ret = devm_iio_device_register(dev, iio);
>  	if (ret) {
> @@ -826,13 +957,15 @@ static void opt3001_remove(struct i2c_client *client)
>  }
>  
>  static const struct i2c_device_id opt3001_id[] = {
> -	{ "opt3001" },
> +	{ "opt3001", 0 },
> +	{ "opt3002", 1 },

Use the same match data for all ID tables. Otherwise you run into
problems for different match methods.

>  	{ } /* Terminating Entry */
>  };
>  MODULE_DEVICE_TABLE(i2c, opt3001_id);
>  
>  static const struct of_device_id opt3001_of_match[] = {
> -	{ .compatible = "ti,opt3001" },
> +	{ .compatible = "ti,opt3001", .data = &opt3001_chip_info },
> +	{ .compatible = "ti,opt3002", .data = &opt3002_chip_info },
Best regards,
Krzysztof