[PATCH net 2/2] net: phy: aquantia: fix applying active_low bit after reset

[Daniel Golle]

for_each_set_bit was used wrongly in aqr107_config_init() when iterating
over LEDs. Drop misleading 'index' variable and call
aqr_phy_led_active_low_set() for each set bit representing an LED which
is driven by VDD instead of GND pin.

Fixes: 61578f679378 ("net: phy: aquantia: add support for PHY LEDs")
Signed-off-by: Daniel Golle <daniel@xxxxxxxxxxxxxx>
---
 drivers/net/phy/aquantia/aquantia_main.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/net/phy/aquantia/aquantia_main.c b/drivers/net/phy/aquantia/aquantia_main.c
index e982e9ce44a59..650df261eea8e 100644
--- a/drivers/net/phy/aquantia/aquantia_main.c
+++ b/drivers/net/phy/aquantia/aquantia_main.c
@@ -478,7 +478,7 @@ static int aqr107_config_init(struct phy_device *phydev)
 {
 	struct aqr107_priv *priv = phydev->priv;
 	u32 led_active_low;
-	int ret, index = 0;
+	int ret;
 
 	/* Check that the PHY interface type is compatible */
 	if (phydev->interface != PHY_INTERFACE_MODE_SGMII &&
@@ -505,10 +505,9 @@ static int aqr107_config_init(struct phy_device *phydev)
 
 	/* Restore LED polarity state after reset */
 	for_each_set_bit(led_active_low, &priv->leds_active_low, AQR_MAX_LEDS) {
-		ret = aqr_phy_led_active_low_set(phydev, index, led_active_low);
+		ret = aqr_phy_led_active_low_set(phydev, led_active_low, true);
 		if (ret)
 			return ret;
-		index++;
 	}
 
 	return 0;
-- 
2.46.1