Re: [PATCH v2 6/7] arm64: dts: qcom: qrb4210-rb2: add description of lpi_i2s2 pins

[Krzysztof Kozlowski]

On 02/10/2024 04:20, Alexey Klimov wrote:
> This is required to enable to HDMI audio playback on
> QRB4210 RB2 board.
> 
> Signed-off-by: Alexey Klimov <alexey.klimov@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 36 ++++++++++++++++++++++++
>  1 file changed, 36 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> index 1888d99d398b..7731681688d5 100644
> --- a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> +++ b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> @@ -634,6 +634,42 @@ sdc2_card_det_n: sd-card-det-n-state {
>  	};
>  };
>  
> +&lpass_tlmm {
> +	lpi_i2s2_active: lpi-i2s2-active-state {
> +		sck-pin {

It does not look like you tested the DTS against bindings. Please run
`make dtbs_check W=1` (see
Documentation/devicetree/bindings/writing-schema.rst or
https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
for instructions).

Best regards,
Krzysztof