Re: [PATCH 1/2] dt-bindings: mmc: mmc-pwrseq-simple: add support for reset control
From: Rob Herring
Date: Mon Oct 07 2024 - 12:00:17 EST
On Mon, Oct 07, 2024 at 03:32:42PM +0000, POPESCU Catalin wrote:
> On 05/10/2024 20:26, Rob Herring wrote:
> > [Some people who received this message don't often get email from robh@xxxxxxxxxx. Learn why this is important at https://aka.ms/LearnAboutSenderIdentification ]
> >
> > This email is not from Hexagon’s Office 365 instance. Please be careful while clicking links, opening attachments, or replying to this email.
> >
> >
> > On Fri, Oct 04, 2024 at 02:07:39PM +0200, Catalin Popescu wrote:
> >> Add compatible value "mmc-pwrseq-simple-reset" to support reset control
> >> instead of gpios. Reset controls being refcounted, they allow to use
> >> shared resets or gpios across drivers. Support of reset control is
> >> limited to one single reset control.
> > Can't you do this without a binding change? Just use reset controls when
> > there is only 1 GPIO.
>
> That's a good question. The idea was to keep in place the gpio support
> w/o impacting any platform using pwrseq-simple.
Why would it matter? If not shared, then the behavior should be the
same. If shared, we want to maintain the broken behavior?
>
> Also, later on when support for a list of reset gpios will be added to
> the reset framework, this would not work anymore...
Why not?
How an OS handles reset-gpios is up to the OS. It can evolve. The
binding can't evolve because it is an ABI.
Also, a list is kind of broken to begin with for a "generic" binding.
What's the order the lines should be asserted/deasserted? What about
timing requirements? You don't know because every device is different.
This binding would not be accepted now, so extending it is questionable.
Rob