On Fri, Oct 11, 2024 at 01:16:19PM +0530, Krishna Kurapati wrote:Adding vbus boost pinctrl and changing dr_mode to host must be enough for this case.
Enable primary USB controller on QCS8300 Ride platform. The primary USB
controller is made "peripheral", as this is intended to be connected to
a host for debugging use cases.
Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
index 7eed19a694c3..3e925228379c 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
@@ -265,3 +265,26 @@ &ufs_mem_phy {
vdda-pll-supply = <&vreg_l5a>;
status = "okay";
};
+
+&usb_1_hsphy {
+ vdda-pll-supply = <&vreg_l7a>;
+ vdda18-supply = <&vreg_l7c>;
+ vdda33-supply = <&vreg_l9a>;
+
+ status = "okay";
+};
+
+&usb_qmpphy {
+ vdda-phy-supply = <&vreg_l7a>;
+ vdda-pll-supply = <&vreg_l5a>;
+
+ status = "okay";
+};
+
+&usb_1 {
+ status = "okay";
+};
+
+&usb_1_dwc3 {
+ dr_mode = "peripheral";
+};
So, can it be used as a USB host controller / connector? What needs to
be done in such a case?