Re: [PATCH v6 3/7] dt-bindings: iio: accel: adxl345: add interrupt-names

[Krzysztof Kozlowski]

On Wed, Dec 11, 2024 at 11:06:44PM +0000, Lothar Rubusch wrote:
> Add interrupt-names INT1 and INT2 for the two interrupt lines of the
> sensor. Only one line will be connected for incoming events. The driver
> needs to be configured accordingly. If no interrupt line is set up, the
> sensor will fall back to FIFO bypass mode and still measure, but no
> interrupt based events are possible.

There was interrupt before and it was required, so I do not understand
last statement. You describe case which is impossible.

Best regards,
Krzysztof