Re: [PATCH v6 3/7] dt-bindings: iio: accel: adxl345: add interrupt-names

[Jonathan Cameron]

On Thu, 12 Dec 2024 09:08:22 +0100
Krzysztof Kozlowski <krzk@xxxxxxxxxx> wrote:

> On Wed, Dec 11, 2024 at 11:06:44PM +0000, Lothar Rubusch wrote:
> > Add interrupt-names INT1 and INT2 for the two interrupt lines of the
> > sensor. Only one line will be connected for incoming events. The driver
> > needs to be configured accordingly.
This is all driver info.  This patch description just needs to say something
like:
"
There are two interrupt lines that may be connected. As the device can
route each type of interrupt to one or other of those lines, interrupt-names
is necessary for two reasons.

- One interrupt line is connected, the device has to be configured to send
  interrupts to that line.
- Two interrupt lines connected.  The device can route all interrupts to 
  one line or elect to split them up.

If no interrupt lines are connected, device functionality may be restricted.
"

Note as below, the required interrupts entry should be removed in a precursor
patch.

> If no interrupt line is set up, the
> > sensor will fall back to FIFO bypass mode and still measure, but no
> > interrupt based events are possible.  
> 
> There was interrupt before and it was required, so I do not understand
> last statement. You describe case which is impossible.

Binding was wrong. Interrupt isn't required for quite a bit of the functionality.

I'd like to see an earlier patch removing that required entry and explaining
why rather than jumping into adding the new interrupt-names part without
resolving that.  Its a relaxation of constraints so probably no need to backport
that patch.

Jonathan


> 
> Best regards,
> Krzysztof
>