Re: [PATCH v3 1/6] dt-bindings: PCI: Add binding for qps615

From: Manivannan Sadhasivam
Date: Mon Feb 10 2025 - 02:52:11 EST


On Wed, Dec 04, 2024 at 02:19:56PM +0530, Krishna Chaitanya Chundru wrote:

[...]

> > > > +                pcie@3,0 {
> > > > +                    reg = <0x21800 0x0 0x0 0x0 0x0>;
> > > > +                    #address-cells = <3>;
> > > > +                    #size-cells = <2>;
> > > > +                    device_type = "pci";
> > > > +                    ranges;
> > > > +                    bus-range = <0x05 0xff>;
> > > > +
> > > > +                    qcom,tx-amplitude-millivolt = <10>;
> > > > +                    pcie@0,0 {
> > > > +                        reg = <0x50000 0x0 0x0 0x0 0x0>;
> > > > +                        #address-cells = <3>;
> > > > +                        #size-cells = <2>;
> > > > +                        device_type = "pci";
> > >
> > > There's a 2nd PCI-PCI bridge?
> > This the embedded ethernet port which is as part of DSP3.
> >
> Hi Rob,
>
> Can you please check my response on your queries, if you need
> any extra information, we can provide to sort this out.
>

I believe Rob was pointing the 'device_type' property which is not needed for
PCI device nodes but only for nodes implementing PCI bus (like host bridge, PCI
bridge).

- Mani

--
மணிவண்ணன் சதாசிவம்