Re: [PATCH v3 1/6] dt-bindings: PCI: Add binding for qps615

[Krishna Chaitanya Chundru]

On 2/10/2025 1:21 PM, Manivannan Sadhasivam wrote:
> On Wed, Dec 04, 2024 at 02:19:56PM +0530, Krishna Chaitanya Chundru wrote:
>
> [...]
>
> > > > > +                pcie@3,0 {
> > > > > +                    reg = <0x21800 0x0 0x0 0x0 0x0>;
> > > > > +                    #address-cells = <3>;
> > > > > +                    #size-cells = <2>;
> > > > > +                    device_type = "pci";
> > > > > +                    ranges;
> > > > > +                    bus-range = <0x05 0xff>;
> > > > > +
> > > > > +                    qcom,tx-amplitude-millivolt = <10>;
> > > > > +                    pcie@0,0 {
> > > > > +                        reg = <0x50000 0x0 0x0 0x0 0x0>;
> > > > > +                        #address-cells = <3>;
> > > > > +                        #size-cells = <2>;
> > > > > +                        device_type = "pci";
> > > >
> > > > There's a 2nd PCI-PCI bridge?
> > > This the embedded ethernet port which is as part of DSP3.
> > Hi Rob,
> >
> > Can you please check my response on your queries, if you need
> > any extra information, we can provide to sort this out.
>
> I believe Rob was pointing the 'device_type' property which is not needed for
> PCI device nodes but only for nodes implementing PCI bus (like host bridge, PCI
> bridge).
Got it, I will remove device_type in the next patch series.

- Krishna Chaitanya.
> - Mani