Re: [PATCH v2 8/8] arm64: dts: rockchip: Enable SD-card interface on Radxa E20C

[Chukun Pan]

Hi,

> +&sdmmc {
> +	bus-width = <4>;
> +	cap-mmc-highspeed;
> +	cap-sd-highspeed;
> +	disable-wp;
> +	no-sdio;

With 'no-sdio' property:
[  129.608986] mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[  130.711168] mmc1: Card stuck being busy! __mmc_poll_for_busy
[  130.725536] mmc_host mmc1: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[  131.751240] mmc1: Card stuck being busy! __mmc_poll_for_busy
[  131.765608] mmc_host mmc1: Bus speed (slot 0) = 200000Hz (slot req 200000Hz, actual 200000HZ div = 0)
[  132.825083] mmc1: Card stuck being busy! __mmc_poll_for_busy
[  132.839413] mmc_host mmc1: Bus speed (slot 0) = 187500Hz (slot req 187500Hz, actual 187500HZ div = 0)
[  133.960141] mmc1: Card stuck being busy! __mmc_poll_for_busy

Without 'no-sdio' property:
[  105.224019] mmc1: error -22 whilst initialising SDIO card
[  106.290838] mmc1: Card stuck being busy! __mmc_poll_for_busy
[  106.801931] dwmmc_rockchip ffc30000.mmc: Busy; trying anyway
[  107.385835] mmc_host mmc1: Timeou sending command (cmd 0x202000 arg 0x0 status 0x80202000)
[  107.400425] mmc_host mmc1: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[  107.431561] mmc_host mmc1: Bus speed (slot 0) = 49800000Hz (slot req 50000000Hz, actual 49800000HZ div = 0)
[  107.433107] mmc1: new high speed SDIO card at address 0001

# cat /sys/kernel/debug/mmc1/ios
clock:          50000000 Hz
vdd:            21 (3.3 ~ 3.4 V)
bus mode:       2 (push-pull)
chip select:    0 (don't care)
power mode:     2 (on)
bus width:      2 (4 bits)
timing spec:    2 (sd high-speed)
signal voltage: 0 (3.30 V)
driver type:    0 (driver type B)

Thanks,
Chukun

-- 
2.25.1