Re: [PATCH 1/2] dt-bindings: i2c: omap: Add mux-states property

[Ing. Josua Mayer]

Hi Jayesh,

Am 18.03.25 um 11:36 schrieb Jayesh Choudhary:
> Add mux controller support for when the I2C lines are muxed after
> signals come out of SoC and before they go to any client.
>
> Signed-off-by: Jayesh Choudhary <j-choudhary@xxxxxx>
> ---
>   Documentation/devicetree/bindings/i2c/ti,omap4-i2c.yaml | 6 ++++++
>   1 file changed, 6 insertions(+)

Is there any chance for this to be generic across any i2c controller
regardless of SoC in use?
Is this perhaps also generic to any device in dts,
similar to assigned-clocks?

E.g. in k3-am642-hummingboard-t-{pcie,usb3}.dts we have a mux on the 
carrier board switching a serdes lane between two different connectors.
It would make sense for pcie and usb phy nodes to delay probe in a 
similar fashion.
The same may hold true for other buses muxed at boot-time or based on 
assembly options or extension cards.

sincerely
Josua Mayer