Re: [PATCH 1/2] dt-bindings: i2c: omap: Add mux-states property

[Rob Herring]

On Tue, Mar 18, 2025 at 2:55 PM Ing. Josua Mayer <josua.mayer@xxxxxx> wrote:
>
> Hi Jayesh,
>
> Am 18.03.25 um 11:36 schrieb Jayesh Choudhary:
> > Add mux controller support for when the I2C lines are muxed after
> > signals come out of SoC and before they go to any client.
> >
> > Signed-off-by: Jayesh Choudhary <j-choudhary@xxxxxx>
> > ---
> >   Documentation/devicetree/bindings/i2c/ti,omap4-i2c.yaml | 6 ++++++
> >   1 file changed, 6 insertions(+)
>
> Is there any chance for this to be generic across any i2c controller
> regardless of SoC in use?
> Is this perhaps also generic to any device in dts,
> similar to assigned-clocks?

$ git grep assigned-clocks arch/ | wc -l
2097

>
> E.g. in k3-am642-hummingboard-t-{pcie,usb3}.dts we have a mux on the
> carrier board switching a serdes lane between two different connectors.
> It would make sense for pcie and usb phy nodes to delay probe in a
> similar fashion.
> The same may hold true for other buses muxed at boot-time or based on
> assembly options or extension cards.

$ git grep mux-states arch/
arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts:
mux-states = <&mux0 1>;
arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts:
mux-states = <&mux0 1>;
arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts:
mux-states = <&mux1 1>;
arch/arm64/boot/dts/ti/k3-j784s4-j742s2-evm-common.dtsi:
 mux-states = <&mux1 1>;

I'm not convinced it is common enough to allow everywhere.

Rob