Re: [RFC v2 0/5] md/raid1: introduce a new sync action to repair badblocks
From: Zheng Qixing
Date: Wed Feb 04 2026 - 04:32:28 EST
resend..
在 2026/2/4 0:31, Christoph Hellwig 写道:
On Tue, Feb 03, 2026 at 04:08:23PM +0800, Zheng Qixing wrote:
Hi,Well, what devices do you see where writes fail, but rewrites
在 2026/2/3 15:31, Christoph Hellwig 写道:
Just curious, but what kind of devices do you see that haveThe bad_blocks entries record sectors where I/O failed, which
permanent bad blocks at a fixed location that are not fixed by
rewriting the sector?
indicates that the device-internal remapping did not succeed
at that time.
`rectify` does not assume a permanently bad or fixed LBA. Its
purpose is to trigger an additional rewrite, giving the underlying
device (e.g. FTL or firmware) another opportunity to perform its
own remapping.
fix them?
I understand your concerns, but I do not have a concrete example tied
to a specific device model...
The intent here is to provide an additional rewrite opportunity, which
allows the write path to be exercised again and gives the underlying
device or stack a chance to recover or remap the affected range.
For remote storage devices, I/O may fail due to network or transport
issues. If the final attempt fails, MD can record the affected range in
bad_blocks. This behavior does not appear to be tied to a specific
device model.
For local storage, some controllers may have limitations or corner cases
in their remapping mechanisms. In such cases, a sector that could
potentially be recovered may be marked as bad, leaving no opportunity
for a subsequent successful rewrite.