Re: [PATCH v2 2/3] arm64: dts: qcom: sm8550: add OSM L3 node and cpu interconnect nodes

[Imran Shaik]

On 19-02-2026 02:59 pm, Konrad Dybcio wrote:
> On 2/18/26 7:16 PM, Aaron Kling via B4 Relay wrote:
> > From: Aaron Kling <webgeek1234@xxxxxxxxx>
> >
> > Add the OSC L3 Cache controller node.
> >
> > Also add the interconnect entry for each cpu, with 3 different paths:
> > - CPU to Last Level Cache Controller (LLCC)
> > - Last Level Cache Controller (LLCC) to DDR
> > - L3 Cache from CPU to DDR interface
> >
> > Signed-off-by: Aaron Kling <webgeek1234@xxxxxxxxx>
> > ---
>
> This should still be squashed with patch 3, as while you wire up the
> CPUs as interconnect consumers, they cast no vote, leading to the
> situation Krzysztof mentioned where the performance actually majorly
> goes *down*, since the icc core sees no users present and assumes it can
> send a zero-vote (which probably translates to F_MIN for the cache)
>
> Konrad

Yes, this is required to be squashed with patch 3.

If only the interconnects are there, without opp-table support, then the 
cpufreq driver probe will fail while adding the opp table, due to 
mismatch between opp-peak-kBps and paths count.

https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/drivers/opp/of.c#n779

Thanks,
Imran