[PATCH 30/40] arm64: dts: rockchip: Add frl-enable-gpios to rk3588s-gameforce-ace

[Cristian Ciocaltea]

The board exposes the GPIO4_B3 line to control the voltage bias on the
HDMI0 data lines.  It must be asserted when operating in HDMI 2.1 FRL
mode and deasserted for HDMI 1.4/2.0 TMDS mode.

Wire up the HDMI0 node to the GPIO line using the frl-enable-gpios
property and drop the line from hdmi0-con to allow adjusting the bias
when transitioning between TMDS and FRL operating modes.

Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/rockchip/rk3588s-gameforce-ace.dts | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588s-gameforce-ace.dts b/arch/arm64/boot/dts/rockchip/rk3588s-gameforce-ace.dts
index 89618394c0bf..0270e5b046eb 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588s-gameforce-ace.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588s-gameforce-ace.dts
@@ -302,9 +302,6 @@ amp_headphone: headphone-amplifier {
 
 	hdmi0-con {
 		compatible = "hdmi-connector";
-		ddc-en-gpios = <&gpio4 RK_PB3 GPIO_ACTIVE_HIGH>;
-		pinctrl-0 = <&hdmi0_en>;
-		pinctrl-names = "default";
 		type = "d";
 
 		port {
@@ -515,8 +512,9 @@ &gpu {
 &hdmi0 {
 	no-hpd;
 	pinctrl-0 = <&hdmim0_tx0_cec>, <&hdmim0_tx0_scl>,
-		    <&hdmim0_tx0_sda>;
+		    <&hdmim0_tx0_sda>, <&hdmi0_frl_en>;
 	pinctrl-names = "default";
+	frl-enable-gpios = <&gpio4 RK_PB3 GPIO_ACTIVE_LOW>;
 	status = "okay";
 };
 
@@ -893,7 +891,7 @@ charger_int_h: charger-int-h {
 	};
 
 	hdmi {
-		hdmi0_en: hdmi0-en {
+		hdmi0_frl_en: hdmi0-frl-en {
 			rockchip,pins =
 				<4 RK_PB3 RK_FUNC_GPIO &pcfg_pull_none>;
 		};

-- 
2.53.0