[PATCH 33/40] arm64: dts: rockchip: Add frl-enable-gpios to rk3588s-nanopi-r6

[Cristian Ciocaltea]

The board exposes the GPIO4_B6 line to control the voltage bias on the
HDMI0 data lines.  It must be asserted when operating in HDMI 2.1 FRL
mode and deasserted for HDMI 1.4/2.0 TMDS mode.

Wire up the HDMI0 node to the GPIO line using the frl-enable-gpios
property to allow adjusting the bias when transitioning between TMDS and
FRL operating modes.

Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/rockchip/rk3588s-nanopi-r6.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588s-nanopi-r6.dtsi b/arch/arm64/boot/dts/rockchip/rk3588s-nanopi-r6.dtsi
index 1b6a59f7cabc..d4560c0d6cd1 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588s-nanopi-r6.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3588s-nanopi-r6.dtsi
@@ -236,6 +236,9 @@ &gpu {
 };
 
 &hdmi0 {
+	pinctrl-0 = <&hdmim0_tx0_cec &hdmim0_tx0_hpd
+		     &hdmim0_tx0_scl &hdmim0_tx0_sda &hdmi0_frl_en>;
+	frl-enable-gpios = <&gpio4 RK_PB6 GPIO_ACTIVE_LOW>;
 	status = "okay";
 };
 
@@ -404,6 +407,12 @@ lan2_led_pin: lan2-led-pin {
 		};
 	};
 
+	hdmi {
+		hdmi0_frl_en: hdmi0-frl-en {
+			rockchip,pins = <4 RK_PB6 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+	};
+
 	hym8563 {
 		rtc_int: rtc-int {
 			rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>;

-- 
2.53.0