[PATCH 37/40] arm64: dts: rockchip: Add frl-enable-gpios to rk3588s-radxa-cm5-io

[Cristian Ciocaltea]

The board exposes the GPIO4_B6 line to control the voltage bias on the
HDMI0 data lines.  It must be asserted when operating in HDMI 2.1 FRL
mode and deasserted for HDMI 1.4/2.0 TMDS mode.

Wire up the HDMI0 node to the GPIO line using the frl-enable-gpios
property to allow adjusting the bias when transitioning between TMDS and
FRL operating modes.

Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@xxxxxxxxxxxxx>
---
 arch/arm64/boot/dts/rockchip/rk3588s-radxa-cm5-io.dts | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588s-radxa-cm5-io.dts b/arch/arm64/boot/dts/rockchip/rk3588s-radxa-cm5-io.dts
index f80d5a00a4bd..339df05c6d71 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588s-radxa-cm5-io.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588s-radxa-cm5-io.dts
@@ -120,6 +120,9 @@ &gmac1 {
 };
 
 &hdmi0 {
+	pinctrl-0 = <&hdmim0_tx0_cec &hdmim0_tx0_hpd
+		     &hdmim0_tx0_scl &hdmim0_tx0_sda &hdmi0_frl_en>;
+	frl-enable-gpios = <&gpio4 RK_PB6 GPIO_ACTIVE_LOW>;
 	status = "okay";
 };
 
@@ -217,6 +220,12 @@ usbc0_int: usbc0-int {
 		};
 	};
 
+	hdmi {
+		hdmi0_frl_en: hdmi0-frl-en {
+			rockchip,pins = <4 RK_PB6 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+	};
+
 	usb {
 		vcc5v0_host_en: vcc5v0-host-en {
 			rockchip,pins = <1 RK_PA0 RK_FUNC_GPIO &pcfg_pull_none>;

-- 
2.53.0