Re: [PATCH v4 0/3] ksz87xx: add support for low-loss cable equalizer errata
From: Marek Vasut
Date: Fri Apr 17 2026 - 10:56:03 EST
On 4/17/26 2:44 PM, Fidelio Lawson wrote:
Hello,Thank you for working on this, except for that one nitpick on 1/3, this looks really good !
This patch implements the “Module 3: Equalizer fix for short cables” erratum
described in Microchip document DS80000687C for KSZ87xx switches.
According to the erratum, the embedded PHY receiver in KSZ87xx switches is
tuned by default for long, high-loss Ethernet cables. When operating with
short or low-loss cables (for example CAT5e or CAT6), the PHY equalizer may
over-amplify the incoming signal, leading to internal distortion and link
establishment failures.
Microchip documents two independent mechanisms to mitigate this issue:
adjusting the receiver low‑pass filter bandwidth and reducing the DSP
equalizer initial value. These registers are located in the switch’s
internal LinkMD table and cannot be accessed directly through a
stand‑alone PHY driver.
To keep the PHY‑facing API clean, this series models the erratum handling
as vendor‑specific Clause 22 PHY registers, virtualized by the KSZ8 DSA
driver. Accesses are intercepted by ksz8_r_phy() / ksz8_w_phy() and
translated into the appropriate indirect LinkMD register writes. The
erratum affects the shared PHY analog front‑end and therefore applies
globally to the switch.
Based on review feedback, the user‑visible interface is kept deliberately
simple and predictable:
- A boolean “short‑cable” PHY tunable applies a documented and
conservative preset (LPF bandwidth 62MHz, DSP EQ initial value 0).
This is the recommended KISS interface for the common short‑cable
scenario.
- Two additional integer PHY tunables allow advanced or experimental
tuning of the LPF bandwidth and the DSP EQ initial value. These
controls are orthogonal, have no ordering requirements, and simply
override the corresponding setting when written.
The tunables act as simple setters with no implicit state machine or
invalid combinations, avoiding surprises for userspace and not relying
on extended error reporting or netlink ethtool support.
This series contains:
1. Support for the KSZ87xx low‑loss cable erratum in the KSZ8 DSA driver,
including the short‑cable preset and orthogonal tuning controls.
2. Addition of vendor‑specific PHY tunable identifiers for the
short‑cable preset, LPF bandwidth, and DSP EQ initial value.
3. Exposure of these tunables through the Micrel PHY driver via
get_tunable / set_tunable callbacks.
This version follows the design agreed upon during v3 review and
reworks the interface accordingly.
This series is based on Linux v7.0-rc1.
Signed-off-by: Fidelio Lawson <fidelio.lawson@xxxxxxxxxx>