[PATCH] arm64: dts: qcom: sm8550: add SDHC4 controller node

[William Bright]

Add the SDC4 SDHCI controller node for the SM8550 SoC.

SMMU stream ID 0x80 was sourced from the UEFI bootloader IORT tables,
as SDCC stream IDs are not documented in the register reference manual.
Unlike SDC2, the data path is routed via aggre1_noc, matching
MASTER_SDCC_4 in drivers/interconnect/qcom/sm8550.c.

Tested on the IMDT QCS8550 SBC at high-speed (HS) mode. UHS modes were
masked out as they failed to initialise; the root cause has not yet
been determined. This board is not currently supported in-tree.

Co-developed-by: Tendai Makumire <tendai.makumire@xxxxxxxxxxx>
Signed-off-by: Tendai Makumire <tendai.makumire@xxxxxxxxxxx>
Signed-off-by: William Bright <william.bright@xxxxxxxxxxx>
Tested-by: William Bright <william.bright@xxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sm8550.dtsi | 54 ++++++++++++++++++++++++++++++++++++
 1 file changed, 54 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi
index 912525e9bca6..5abbe519781b 100644
--- a/arch/arm64/boot/dts/qcom/sm8550.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi
@@ -3280,6 +3280,60 @@ opp-202000000 {
 			};
 		};
 
+		sdhc_4: mmc@8844000 {
+			compatible = "qcom,sm8550-sdhci", "qcom,sdhci-msm-v5";
+			reg = <0 0x08844000 0 0x1000>;
+
+			interrupts = <GIC_SPI 261 IRQ_TYPE_LEVEL_HIGH 0>,
+				     <GIC_SPI 227 IRQ_TYPE_LEVEL_HIGH 0>;
+			interrupt-names = "hc_irq", "pwr_irq";
+
+			clocks = <&gcc GCC_SDCC4_AHB_CLK>,
+				 <&gcc GCC_SDCC4_APPS_CLK>,
+				 <&bi_tcxo_div2>;
+			clock-names = "iface", "core", "xo";
+			iommus = <&apps_smmu 0x80 0>;
+			qcom,dll-config = <0x0007642c>;
+			qcom,ddr-config = <0x80040868>;
+			power-domains = <&rpmhpd RPMHPD_CX>;
+			operating-points-v2 = <&sdhc4_opp_table>;
+
+			interconnects = <&aggre1_noc MASTER_SDCC_4 QCOM_ICC_TAG_ALWAYS
+					 &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+					<&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ACTIVE_ONLY
+					 &config_noc SLAVE_SDCC_4 QCOM_ICC_TAG_ACTIVE_ONLY>;
+			interconnect-names = "sdhc-ddr", "cpu-sdhc";
+			bus-width = <4>;
+			max-sd-hs-hz = <37500000>;
+			dma-coherent;
+
+			status = "disabled";
+
+			sdhc4_opp_table: opp-table {
+				compatible = "operating-points-v2";
+
+				opp-19200000 {
+					opp-hz = /bits/ 64 <19200000>;
+					required-opps = <&rpmhpd_opp_min_svs>;
+				};
+
+				opp-50000000 {
+					opp-hz = /bits/ 64 <50000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+				};
+
+				opp-100000000 {
+					opp-hz = /bits/ 64 <100000000>;
+					required-opps = <&rpmhpd_opp_svs>;
+				};
+
+				opp-202000000 {
+					opp-hz = /bits/ 64 <202000000>;
+					required-opps = <&rpmhpd_opp_svs_l1>;
+				};
+			};
+		};
+
 		iris: video-codec@aa00000 {
 			compatible = "qcom,sm8550-iris";
 

---
base-commit: 4f5b4b748ac75683d61c304ee3ee0db235e8f312
change-id: 20260423-sm8550-sdhc4-support-358bf264c04e

Best regards,
--  
William Bright <william.bright@xxxxxxxxxxx>