[PATCH 3/6] dt-bindings: hwmon: (pmbus/max20830): add VOUT feedback resistor properties

From: Alexis Czezar Torreno

Date: Mon Jun 29 2026 - 22:48:30 EST


Add adi,vout-rfb1-ohms and adi,vout-rfb2-ohms properties to support
external voltage divider configuration for VOUT sensing. When the
desired output voltage is higher than VREF, a resistor divider (RFB1
and RFB2) is required to reach the intended value.

The properties use a dependency constraint to ensure both resistors
are specified together, or neither. This prevents misconfiguration
where only one resistor value is provided.

Signed-off-by: Alexis Czezar Torreno <alexisczezar.torreno@xxxxxxxxxx>
---
.../devicetree/bindings/hwmon/pmbus/adi,max20830.yaml | 17 +++++++++++++++++
1 file changed, 17 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
index ab8f6324866f29de8c66c3c63300845b2e02207e..caedad40bc592c8489df235f02c6ff051070cb1e 100644
--- a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
+++ b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
@@ -49,11 +49,26 @@ properties:
GPIO connected to the power-good status output pin.
maxItems: 1

+ adi,vout-rfb1-ohms:
+ description:
+ Top feedback resistor (RFB1) value in ohms for VOUT sensing divider.
+ When the desired output voltage is higher than VREF, a resistor divider
+ is required. VOUT = VREF × (1 + RFB1/RFB2)
+
+ adi,vout-rfb2-ohms:
+ description:
+ Bottom feedback resistor (RFB2) value in ohms for VOUT sensing divider.
+ Datasheet recommends that RFB2 does not exceed 2.5kΩ.
+
required:
- compatible
- reg
- vddh-supply

+dependencies:
+ adi,vout-rfb1-ohms: ['adi,vout-rfb2-ohms']
+ adi,vout-rfb2-ohms: ['adi,vout-rfb1-ohms']
+
unevaluatedProperties: false

examples:
@@ -66,6 +81,8 @@ examples:
compatible = "adi,max20830";
reg = <0x30>;
vddh-supply = <&vddh>;
+ adi,vout-rfb1-ohms = <10000>;
+ adi,vout-rfb2-ohms = <2000>;
};
};
...

--
2.34.1