Re: [PATCH RFC 2/6] ASoC: qcom: sdm845: use DSP_A format for TDM codec DAIs

[David Heidelberg]

On 06/07/2026 10:33, Konrad Dybcio wrote:
> On 7/5/26 10:06 PM, David Heidelberg via B4 Relay wrote:
> > From: David Heidelberg <david@xxxxxxx>
> >
> > Before the DSP_B only worked because the only close-to-mainline consumer
> > cs35l36 codec was patched to map both DSP_A and DSP_B to the same
> > hardware register value (asp_fmt = 0), which is inherently DSP_A timing.
> > Use the right codec (DSP_A) which works as expected.
> >
> > Signed-off-by: David Heidelberg <david@xxxxxxx>
> > ---
>
> Fixes?

I was thinking about it, but I don't see any mainline consumer of TDM within the 
sdm845 arch.

If you think it make sense, I'll mark it.

David

> Konrad