Re: [PATCH v3 1/2] arm64: dts: qcom: shikra-iqs-evk: Add LT9611UXD HDMI bridge support

[Krzysztof Kozlowski]

On 28/07/2026 14:00, Mohit Dsor wrote:
> Enable the Shikra MDSS display subsystem on the Qualcomm Shikra IQS
> EVK board and add the Lontium LT9611UXD DSI-to-HDMI bridge node.
> 
> The LT9611UXD is connected via I2C (bus 4, address 0x41), powered by
> a GPIO-controlled 3.3V regulator (PM8150 GPIO4) and an always-on 1.8V
> rail. Reset is on GPIO76 and interrupt on GPIO85.
> 
> The bridge receives DSI output from MDSS and drives an HDMI-A
> connector, with the link wired as: DPU -> DSI0 -> LT9611UXD -> HDMI.
> 
> Signed-off-by: Mohit Dsor <mohit.dsor@xxxxxxxxxxxxxxxx>
> ---

Did you ignore here previous review as well, just like you did on
LT9611C patchset?

Best regards,
Krzysztof