Re: [PATCH v2 09/15] pinctrl: qcom: Add Kuno pinctrl driver

[Hardeep Sharma]

On 8/17/2026 6:54 PM, Konrad Dybcio wrote:
> On 8/14/26 9:31 AM, Hardeep Sharma wrote:
> > Add the TLMM pinctrl driver for the Qualcomm Kuno platform, supporting
> > 110 GPIOs and their pin multiplexing, pin configuration and gpiolib
> > interface through the common pinctrl-msm driver.
> >
> > Signed-off-by: Hardeep Sharma <hardeep.sharma@xxxxxxxxxxxxxxxx>
> > ---
> [...]
>
> > +	[65] = PINGROUP(65, qup0_se1, qdss_cti_trig1, qdss_cti_trig1, NA, NA, NA, NA, NA, NA),
> > +	[66] = PINGROUP(66, qup0_se1, qdss_cti_trig1, qdss_cti_trig1, NA, NA, NA, NA, NA, NA),
> Function3 can't be selected because of repeating names
>
> In qdss_cti_trig1_groups, you have qdss_cti_trig1 specified twice.
> Perhaps there was a longer name that got truncated?
>
> Konrad

Thanks Konrad for review.

It's a real qdss_cti_trig1 line - the in/out
mirror partner of funcsel 2:

   GPIO65: fsel2 = qdss_cti_trig1_in_mirb, fsel3 = qdss_cti_trig1_out_mire
   GPIO66: fsel2 = qdss_cti_trig1_out_mirb, fsel3 = qdss_cti_trig1_in_mire

Both map to the same name because the driver uses one coarse
"qdss_cti_trig1" for the in/out mirror variants.

Listing the function on both funcsels is the normal sdx convention for
these mirror pairs - the in-tree drivers do it, including the same pins
on sdx65:

   - sdx55 [16][17][22][23][54][55][94][95] → in pinctrl-sdx55.c, pins
16, 17, 22, 23, 54, 55, 94, 95 each repeat qdss_cti at two funcsels.
   - sdx65 [65]/[66] → in pinctrl-sdx65.c, pins 65 and 66 do it —
   - sdx75 [16][52][53][56][57][78][79] → in pinctrl-sdx75.c, those pins
do it.

Only funcsel 2
is selectable from DT (first-match), which is expected and matches those
drivers.

Best Wishes

Hardeep Sharma