Re: [PATCH] sh: intc: sort the prio and sense lists after filling them

[John Paul Adrian Glaubitz]

Hi Geert,

On Mon, 2026-09-28 at 18:03 +0200, Geert Uytterhoeven wrote:
> On Mon, 28 Sept 2026 at 17:10, John Paul Adrian Glaubitz
> <glaubitz@xxxxxxxxxxxxxxxxxxx> wrote:
> > => usb reset; fatload usb 0:1 0x89000000 uImage-7.3.0.gz ; pmb ; bootm
> > (Re)start USB...
> > USB0:   scanning bus 0 for devices... 2 USB Device(s) found
> >        scanning usb for storage devices... 1 Storage Device(s) found
> > reading uImage-7.3.0.gz
> > 3649306 bytes read in 2074 ms (1.7 MiB/s)
> > ## Booting kernel from Legacy Image at 89000000 ...
> >    Image Name:   Linux-7.3.0-rc5-00001-g8cd915e93
> >    Image Type:   SuperH Linux Kernel Image (gzip compressed)
> >    Data Size:    3649242 Bytes = 3.5 MiB
> >    Load Address: 8c010000
> >    Entry Point:  8c011000
> >    Verifying Checksum ... OK
> >    Uncompressing Kernel Image ... OK
> > 
> > I also never understood why the load address I used at the u-boot prompt
> > differed from the one that the uImage build process showed at the end of
> > the kernel build:
> > 
> >   GZIP    arch/sh/boot/vmlinux.bin.gz
> >   UIMAGE  arch/sh/boot/uImage.gz
> > Image Name:   Linux-7.3.0-rc5-00002-g02d53450e
> > Created:      Mon Sep 28 14:56:15 2026
> > Image Type:   SuperH Linux Kernel Image (gzip compressed)
> > Data Size:    3649249 Bytes = 3563.72 KiB = 3.48 MiB
> > Load Address: 8c010000
> > Entry Point:  8c011000
> >   Image arch/sh/boot/uImage is ready
> > 
> > Any idea?
> 
> 0x89000000 is the address where you load the uImage.
> 0x8c010000 is the address where the unpacked kernel image will be
> stored.
> 
> The latter comes from your kernel config:
> 
>     arch/sh/boot/Makefile:UIMAGE_LOADADDR = $(KERNEL_LOAD)
>     arch/sh/boot/Makefile:UIMAGE_ENTRYADDR = $(KERNEL_ENTRY)
> 
> It's similar on ARM platforms that (still) use uImage.

The thing is that it stopped working after 6.5.0 and I never figured
out why. I did test all kinds of changes and it just never worked
again while pre 6.5.0 kernels work just fine.

Adrian

-- 
 .''`.  John Paul Adrian Glaubitz
: :' :  Debian Developer
`. `'   Physicist
  `-    GPG: 62FF 8A75 84E0 2956 9546  0006 7426 3B37 F5B5 F913