Re: [net-next,PATCH v2] enetc: Increase eMDIO MDC rate to 2.5 MHz

[Andrew Lunn]

> No, we typically hardcode the clock frequency in the driver based on the NETC
> version. Another simple method is to set the divisor to 166 instead of 66, which
> will not cause any problems for using a 400MHz NETC.

There are use cases where you want the MDIO bus running at the 802.3
speed, or higher.

Some PHYs need firmware download because the OEM saved $0.02 by not
putting on an EEPROM. I've seen boards take 10s of seconds to download
the firmware on boot.

The Marvell PHYs allow you access to the raw TDR cable testing values,
which is a lot of data. Getting it faster allows nicer and more
responsive tools.

There might be an MDIO managed switch hanging off the MDIO bus, so
again, lots of traffic.

So please look at setting the divisor correctly to achieve 2.5Mhz, and
maybe consider implementing the device tree property:

  clock-frequency:
    description:
      Desired MDIO bus clock frequency in Hz. Values greater than IEEE 802.3
      defined 2.5MHz should only be used when all devices on the bus support
      the given clock speed.

so it can be overclocked.

   Andrew