[PATCH net-next 1/3] net: sb1250-mac: Add ethtool link settings support

[Florian Fainelli]

The driver connects to its PHY through phylib, but does not provide
ethtool operations. As a result, ethtool cannot report or configure the
link settings.

Use the phylib get_link_ksettings and set_link_ksettings helpers, and
provide ethtool_op_get_link for carrier reporting. The helpers return
-ENODEV when the PHY is not attached, as the driver attaches it when
the interface is opened and disconnects it when the interface is closed.

Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
 drivers/net/ethernet/broadcom/sb1250-mac.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/net/ethernet/broadcom/sb1250-mac.c b/drivers/net/ethernet/broadcom/sb1250-mac.c
index c839dd9804d3..1843b52e96f5 100644
--- a/drivers/net/ethernet/broadcom/sb1250-mac.c
+++ b/drivers/net/ethernet/broadcom/sb1250-mac.c
@@ -2128,6 +2128,12 @@ static void sbmac_setmulti(struct sbmac_softc *sc)
 	}
 }
 
+static const struct ethtool_ops sbmac_ethtool_ops = {
+	.get_link		= ethtool_op_get_link,
+	.get_link_ksettings	= phy_ethtool_get_link_ksettings,
+	.set_link_ksettings	= phy_ethtool_set_link_ksettings,
+};
+
 static const struct net_device_ops sbmac_netdev_ops = {
 	.ndo_open		= sbmac_open,
 	.ndo_stop		= sbmac_close,
@@ -2197,6 +2203,7 @@ static int sbmac_init(struct platform_device *pldev, long long base)
 	spin_lock_init(&(sc->sbm_lock));
 
 	dev->netdev_ops = &sbmac_netdev_ops;
+	dev->ethtool_ops = &sbmac_ethtool_ops;
 	dev->watchdog_timeo = TX_TIMEOUT;
 	dev->min_mtu = 0;
 	dev->max_mtu = ENET_PACKET_SIZE;
-- 
2.53.0