[PATCH] hwmon: (sht3x) Fix alarm attribute names in documentation
From: Wayne Ho
Date: Thu Nov 12 2026 - 01:06:34 EST
The description of the periodic measure mode says that "the alert
attribute" is set when a reading exceeds the configured limits. The
driver has no such attribute, and never had one. The alarm state has
been exposed through temp1_alarm and humidity1_alarm since the driver
was added, which is also what the sysfs interface table further down in
the same document lists.
Refer to the actual attribute names.
Fixes: 7c84f7f80d6f ("hwmon: add support for Sensirion SHT3x sensors")
Signed-off-by: Wayne Ho <wayneho219@xxxxxxxxx>
---
Documentation/hwmon/sht3x.rst | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/Documentation/hwmon/sht3x.rst b/Documentation/hwmon/sht3x.rst
index 4f67671eb0c..3c022c058be 100644
--- a/Documentation/hwmon/sht3x.rst
+++ b/Documentation/hwmon/sht3x.rst
@@ -78,11 +78,11 @@ The allowed update_interval in milliseconds are as follows:
In the periodic measure mode, the sensor automatically triggers a measurement
with the configured update interval on the chip. When a temperature or humidity
-reading exceeds the configured limits, the alert attribute is set to 1 and
-the alert pin on the sensor is set to high.
+reading exceeds the configured limits, the temp1_alarm or humidity1_alarm
+attribute is set to 1 and the alert pin on the sensor is set to high.
When the temperature and humidity readings move back between the hysteresis
-values, the alert bit is set to 0 and the alert pin on the sensor is set to
-low.
+values, the alarm attribute is set to 0 and the alert pin on the sensor is set
+to low.
The serial number exposed to debugfs allows for unique identification of the
sensors. For sts32, sts33 and sht33, the manufacturer provides calibration
---
base-commit: 44c8ceae2dd3ae536c5f4f956cedb24c157aac23
change-id: 20261112-sht3x-doc-alarm-attr-118ddfebc6ae
Best regards,
--
Wayne Ho <wayneho219@xxxxxxxxx>