[PATCH net v3 3/7] net: bcm4908_enet: release the TX ring on stop
From: Kordian Chmielewski
Date: Fri Nov 13 2026 - 18:59:21 EST
bcm4908_enet_stop() disables the TX DMA but leaves the ring as it is:
the skbs that poll_tx() has not freed yet stay mapped and are never
freed, and the descriptors the DMA has not sent yet keep
DMA_CTL_STATUS_OWN. The skbs, the socket memory they hold and their
mappings leak. The next open starts the indexes from 0 again over
those descriptors, so the DMA may send stale frames from before the
stop, and if the first descriptor still has OWN, start_xmit() stops
the queue before it enables the DMA, with nothing left to wake it.
Wait for the TX DMA channel to stop, as is already done for RX, then
unmap and free the skbs between read_idx and write_idx and leave the
ring empty, so that nothing can free them a second time. If the
channel does not stop in time, leave the skbs alone rather than free
them while the DMA may still read them. Clear the TX descriptors when
the ring is initialised. A descriptor that start_xmit() is about to
use then never carries OWN, so drop the check that stopped the queue
on one. The RX helper's timeout warning said TX; make it say RX.
Found by reading the code; I have not seen these on the hardware.
Fixes: 4feffeadbcb2 ("net: broadcom: bcm4908enet: add BCM4908 controller driver")
Signed-off-by: Kordian Chmielewski <kudzo51@xxxxxxxxx>
---
drivers/net/ethernet/broadcom/bcm4908_enet.c | 55 ++++++++++++++++----
1 file changed, 44 insertions(+), 11 deletions(-)
diff --git a/drivers/net/ethernet/broadcom/bcm4908_enet.c b/drivers/net/ethernet/broadcom/bcm4908_enet.c
index b1738d954..bb42b6ecd 100644
--- a/drivers/net/ethernet/broadcom/bcm4908_enet.c
+++ b/drivers/net/ethernet/broadcom/bcm4908_enet.c
@@ -7,6 +7,7 @@
#include <linux/etherdevice.h>
#include <linux/if_vlan.h>
#include <linux/interrupt.h>
+#include <linux/iopoll.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_net.h>
@@ -313,6 +314,11 @@ static void bcm4908_enet_dma_ring_init(struct bcm4908_enet *enet,
enet_write(enet, ring->st_ram_block + ENET_DMA_CH_STATE_RAM_BASE_DESC_PTR,
(uint32_t)ring->dma_addr);
+ /* A descriptor the stopped DMA never completed still carries OWN */
+ if (ring->is_tx)
+ memset(ring->buf_desc, 0,
+ ring->length * sizeof(*ring->buf_desc));
+
ring->read_idx = 0;
ring->write_idx = 0;
}
@@ -362,10 +368,22 @@ static void bcm4908_enet_dma_tx_ring_enable(struct bcm4908_enet *enet,
enet_write(enet, ring->cfg_block + ENET_DMA_CH_CFG, ENET_DMA_CH_CFG_ENABLE);
}
-static void bcm4908_enet_dma_tx_ring_disable(struct bcm4908_enet *enet,
- struct bcm4908_enet_dma_ring *ring)
+static int bcm4908_enet_dma_tx_ring_disable(struct bcm4908_enet *enet,
+ struct bcm4908_enet_dma_ring *ring)
{
+ u32 tmp;
+ int err;
+
enet_write(enet, ring->cfg_block + ENET_DMA_CH_CFG, 0);
+
+ /* Wait for the channel to stop, as for RX, before freeing buffers */
+ err = read_poll_timeout(enet_read, tmp, !(tmp & ENET_DMA_CH_CFG_ENABLE),
+ 10, 2000, false, enet,
+ ring->cfg_block + ENET_DMA_CH_CFG);
+ if (err)
+ dev_warn(enet->dev, "Timeout waiting for DMA TX stop\n");
+
+ return err;
}
static void bcm4908_enet_dma_rx_ring_enable(struct bcm4908_enet *enet,
@@ -391,7 +409,7 @@ static void bcm4908_enet_dma_rx_ring_disable(struct bcm4908_enet *enet,
usleep_range(10, 30);
} while (!time_after_eq(jiffies, deadline));
- dev_warn(enet->dev, "Timeout waiting for DMA TX stop\n");
+ dev_warn(enet->dev, "Timeout waiting for DMA RX stop\n");
}
/***
@@ -496,6 +514,25 @@ static int bcm4908_enet_open(struct net_device *netdev)
return 0;
}
+static void bcm4908_enet_tx_ring_clean(struct bcm4908_enet *enet)
+{
+ struct bcm4908_enet_dma_ring *tx_ring = &enet->tx_ring;
+ struct device *dev = enet->dev;
+ int i;
+
+ for (i = tx_ring->read_idx; i != tx_ring->write_idx;
+ i = i == tx_ring->length - 1 ? 0 : i + 1) {
+ struct bcm4908_enet_dma_ring_slot *slot = &tx_ring->slots[i];
+
+ dma_unmap_single(dev, slot->dma_addr, slot->len, DMA_TO_DEVICE);
+ dev_kfree_skb_any(slot->skb);
+ }
+
+ /* Leave the ring empty, so that nothing frees these skbs again */
+ tx_ring->read_idx = 0;
+ tx_ring->write_idx = 0;
+}
+
static int bcm4908_enet_stop(struct net_device *netdev)
{
struct bcm4908_enet *enet = netdev_priv(netdev);
@@ -509,8 +546,10 @@ static int bcm4908_enet_stop(struct net_device *netdev)
netdev_reset_queue(netdev);
bcm4908_enet_dma_rx_ring_disable(enet, &enet->rx_ring);
- bcm4908_enet_dma_tx_ring_disable(enet, &enet->tx_ring);
+ /* Leave the TX buffers alone if the channel may still read them */
+ if (!bcm4908_enet_dma_tx_ring_disable(enet, &enet->tx_ring))
+ bcm4908_enet_tx_ring_clean(enet);
bcm4908_enet_dma_uninit(enet);
free_irq(enet->irq_tx, enet);
@@ -549,13 +588,6 @@ static netdev_tx_t bcm4908_enet_start_xmit(struct sk_buff *skb, struct net_devic
if (!netif_txq_maybe_stop(txq, bcm4908_enet_tx_free_descs(ring), 1, 1))
return NETDEV_TX_BUSY;
- /* Hardware removes OWN bit after sending data */
- buf_desc = &ring->buf_desc[ring->write_idx];
- if (unlikely(le32_to_cpu(buf_desc->ctl) & DMA_CTL_STATUS_OWN)) {
- netif_stop_queue(netdev);
- return NETDEV_TX_BUSY;
- }
-
dma_addr = dma_map_single(dev, skb->data, skb->len, DMA_TO_DEVICE);
if (unlikely(dma_mapping_error(dev, dma_addr))) {
dev_kfree_skb_any(skb);
@@ -563,6 +595,7 @@ static netdev_tx_t bcm4908_enet_start_xmit(struct sk_buff *skb, struct net_devic
return NETDEV_TX_OK;
}
+ buf_desc = &ring->buf_desc[ring->write_idx];
slot = &ring->slots[ring->write_idx];
slot->skb = skb;
slot->len = skb->len;
--
2.56.1