Re: [PATCH v3 2/3] arm64: dts: allwinner: add A733 SoC description

From: Enzo Adriano

Date: Thu Nov 19 2026 - 13:07:17 EST


Hi Alexander,

> Shall parts of this go below "---" as history/changelog?

Yes. In v4 I will move the dated test results below "---" and keep
the hardware rationale in the commit message.

> Do we need capacity-dmips-mhz, cpu-map and two PMUs here, similar
> to rk3588-base.dtsi? This in turn would mean ppi-partitions with
> #interrupt-cells = <4> in GIC?

The A733 manual shows one DynamIQ cluster with six Cortex-A55 cores
(0-5) and two Cortex-A76 cores (6-7) sharing L3 (section 5.1.2,
figure 5-1). Every core's PMU interrupt is PPI 7 (section 12.2.3,
table 12-1).

In v4 I will add a single-cluster cpu-map and separate
arm,cortex-a55-pmu and arm,cortex-a76-pmu nodes on PPI 7 with
ppi-partitions, and switch the GIC to #interrupt-cells = <4>, as
MT8186 does for the same six-plus-two layout.

I will leave capacity-dmips-mhz out until measured on A733. Radxa's
BSP uses 430/1024 without a stated method. In the November 18
RAM boot on Cubie A7S with the v4 DT, CPUs 0-7 were in one cluster,
with the A55 PMU on CPUs 0-5 and the A76 PMU on CPUs 6-7 counting
and receiving PPI 7 overflow interrupts on each CPU.

Thanks,
Enzo