RE: [PATCH v2 2/2] usb: gadget: Add xilinx axi usb2 device support
From: Paul Zimmerman
Date: Wed Apr 16 2014 - 16:08:25 EST
> From: linux-usb-owner@xxxxxxxxxxxxxxx [mailto:linux-usb-owner@xxxxxxxxxxxxxxx] On Behalf Of sundeep subbaraya
> Sent: Wednesday, April 16, 2014 3:39 AM
>
> Hi Felipe,
>
> On Thu, Apr 3, 2014 at 8:28 PM, Felipe Balbi <balbi@xxxxxx> wrote:
>
> >> +static int start_dma(struct xusb_ep *ep, u32 src, u32 dst, u32 length)
> >
> > please prepend this with xudc_, it makes tracing a lot easier.
> >
> >> +{
> >> + struct xusb_udc *udc;
> >> + int rc = 0;
> >> + unsigned long timeout;
> >> +
> >> + udc = ep->udc;
> >> + /*
> >> + * Set the addresses in the DMA source and
> >> + * destination registers and then set the length
> >> + * into the DMA length register.
> >> + */
> >> + udc->write_fn(udc->base_address, XUSB_DMA_DSAR_ADDR_OFFSET, src);
> >> + udc->write_fn(udc->base_address, XUSB_DMA_DDAR_ADDR_OFFSET, dst);
> >> + udc->write_fn(udc->base_address, XUSB_DMA_LENGTH_OFFSET, length);
> >> +
> >> + /*
> >> + * Wait till DMA transaction is complete and
> >> + * check whether the DMA transaction was
> >> + * successful.
> >> + */
> >> + while ((udc->read_fn(ep->udc->base_address + XUSB_DMA_STATUS_OFFSET) &
> >> + XUSB_DMA_DMASR_BUSY) == XUSB_DMA_DMASR_BUSY) {
> >> + timeout = jiffies + 10000;
> >> +
> >> + if (time_after(jiffies, timeout)) {
> >> + rc = -ETIMEDOUT;
> >> + goto clean;
> >> + }
> >> + }
> >
> > don't you get an IRQ for DMA completion ? If you do, you could be using
> > wait_for_completion()
>
> This function is called in interrupt context when buffer is ready or
> free. It initiates
> DMA to transfer data from IP buffer to memory. Hence it waits in busy
> loop till DMA
> completes
If this function is called in interrupt context, then you can't use
jiffies for your timeout, since jiffies may not get updated while in
interrupt context.
--
Paul
N§²æ¸yú²X¬¶ÇvØ)Þ{.nÇ·¥{±êX§¶¡Ü}©²ÆzÚj:+v¨¾«êZ+Êzf£¢·h§~Ûÿû®w¥¢¸?¨è&¢)ßfùy§m
á«a¶Úÿ0¶ìå