Re: msm8996: qcom-qmp: apq8096-db820c fails to boot, reset back to fastboot and locks up
From: Paolo Pisati
Date: Wed Jun 12 2019 - 10:13:55 EST
On Wed, Jun 12, 2019 at 03:17:35PM +0200, Niklas Cassel wrote:
> > diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
> > index cd91b4179b10..22352e3b0ec5 100644
> > --- a/drivers/phy/qualcomm/phy-qcom-qmp.c
> > +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
> > @@ -1490,7 +1490,7 @@ static int qcom_qmp_phy_enable(struct phy *phy)
> >
> > ret = qcom_qmp_phy_com_init(qphy);
> > if (ret)
> > - return ret;
> > + goto err_lane_rst;
> >
> > if (cfg->has_lane_rst) {
> > ret = reset_control_deassert(qphy->lane_rst);
Hi Niklas,
unfortunately, it didn't help - i added a printk, to highlight when it failed:
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -1489,8 +1489,10 @@ static int qcom_qmp_phy_enable(struct phy *phy)
}
ret = qcom_qmp_phy_com_init(qphy);
- if (ret)
- return ret;
+ if (ret) {
+ dev_err(qmp->dev, "qphy initialization failed\n");
+ goto err_lane_rst;
+ }
if (cfg->has_lane_rst) {
ret = reset_control_deassert(qphy->lane_rst);
After several reboots i was able to trigger the phy init failure again:
...
[ 2.223999] qcom-qmp-phy 34000.phy: Registered Qcom-QMP phy
[ 2.224956] qcom-qmp-phy 7410000.phy: Registered Qcom-QMP phy
[ 2.228798] ufs_qcom_phy_qmp_14nm 627000.phy: invalid resource
[ 2.237271] qcom-qmp-phy 34000.phy: phy common block init timed-out
[ 2.240315] qcom-qmp-phy 34000.phy: qphy initialization failed
...
these are the last lines printed, before rebooting in fastboot and
locking up there (as before[*]).
So, as far as i understand there are two distinct problems:
1) sometimes, qcom-qmp-phy fails to initialize
2) and when that happens, the failure is fatal and it led to a reboot & lockup
in fastboot
1: https://pastebin.ubuntu.com/p/rtjVrD3yzk/
--
bye,
p.