Re: [RFT][PATCH 1/2] regulator: lm363x: Fix off-by-one n_voltages for lm3632 ldo_vpos/ldo_vneg

From: Dan Murphy
Date: Tue Jul 16 2019 - 14:09:02 EST


Axel

On 7/7/19 9:02 PM, Axel Lin wrote:
Axel Lin <axel.lin@xxxxxxxxxx> æ 2019å6æ26æ éä äå11:12åéï
Dan Murphy <dmurphy@xxxxxx> æ 2019å6æ26æ éä äå11:07åéï
Hello

On 6/26/19 8:26 AM, Axel Lin wrote:
According to the datasheet https://www.ti.com/lit/ds/symlink/lm3632a.pdf
Table 20. VPOS Bias Register Field Descriptions VPOS[5:0]
Sets the Positive Display Bias (LDO) Voltage (50 mV per step)
000000: 4 V
000001: 4.05 V
000010: 4.1 V
....................
011101: 5.45 V
011110: 5.5 V (Default)
011111: 5.55 V
....................
100111: 5.95 V
101000: 6 V
Note: Codes 101001 to 111111 map to 6 V

The LM3632_LDO_VSEL_MAX should be 0b101000 (0x28), so the maximum voltage
can match the datasheet.

Fixes: 3a8d1a73a037 ("regulator: add LM363X driver")
Signed-off-by: Axel Lin <axel.lin@xxxxxxxxxx>
---
drivers/regulator/lm363x-regulator.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/regulator/lm363x-regulator.c b/drivers/regulator/lm363x-regulator.c
index 5647e2f97ff8..e4a27d63bf90 100644
--- a/drivers/regulator/lm363x-regulator.c
+++ b/drivers/regulator/lm363x-regulator.c
@@ -30,7 +30,7 @@

/* LM3632 */
#define LM3632_BOOST_VSEL_MAX 0x26
-#define LM3632_LDO_VSEL_MAX 0x29
+#define LM3632_LDO_VSEL_MAX 0x28
Similar comment as I made on the LM36274

These are 0 based registers so it is 28 + 1
The code shows: .n_voltages = LM3632_LDO_VSEL_MAX + 1
so LM3632_LDO_VSEL_MAX needs to be 0x28.

.name = "ldo_vpos",
.of_match = "vpos",
.id = LM3632_LDO_POS,
.ops = &lm363x_regulator_voltage_table_ops,
.n_voltages = LM3632_LDO_VSEL_MAX + 1,
Hi Dan,
I'm wondering if you read my previous reply.

Yes I just got to it I was buried with other work. Thanks for the bump on the list.

I will have to try this on my board.

FYI this is not really my code Milo K was the original author.

I just added another entry to the driver. But since Milo is MIA I will

give it a look once I finish up my LED work next week

Dan

<snip>

Regards,
Axel