Re: [PATCH V6 09/21] clk: tegra: clk-super: Fix to enable PLLP branches to CPU
From: Sowjanya Komatineni
Date: Mon Jul 22 2019 - 03:23:57 EST
On 7/22/19 12:17 AM, Dmitry Osipenko wrote:
22.07.2019 10:12, Sowjanya Komatineni ÐÐÑÐÑ:
On 7/21/19 11:32 PM, Dmitry Osipenko wrote:
22.07.2019 6:17, Sowjanya Komatineni ÐÐÑÐÑ:
On 7/21/19 3:39 PM, Sowjanya Komatineni wrote:
On 7/21/19 2:16 PM, Dmitry Osipenko wrote:
21.07.2019 22:40, Sowjanya Komatineni ÐÐÑÐÑ:
This patch has a fix to enable PLLP branches to CPU before changing
the CPU clusters clock source to PLLP for Gen5 Super clock.
During system suspend entry and exit, CPU source will be switched
to PLLP and this needs PLLP branches to be enabled to CPU prior to
the switch.
On system resume, warmboot code enables PLLP branches to CPU and
powers up the CPU with PLLP clock source.
Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
ÂÂ drivers/clk/tegra/clk-super.cÂÂÂÂÂÂÂÂÂÂÂ | 11 +++++++++++
ÂÂ drivers/clk/tegra/clk-tegra-super-gen4.c |Â 4 ++--
ÂÂ drivers/clk/tegra/clk.hÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂ |Â 4 ++++
ÂÂ 3 files changed, 17 insertions(+), 2 deletions(-)
diff --git a/drivers/clk/tegra/clk-super.c
b/drivers/clk/tegra/clk-super.c
index 39ef31b46df5..d73c587e4853 100644
--- a/drivers/clk/tegra/clk-super.c
+++ b/drivers/clk/tegra/clk-super.c
@@ -28,6 +28,9 @@
ÂÂ #define super_state_to_src_shift(m, s) ((m->width * s))
ÂÂ #define super_state_to_src_mask(m) (((1 << m->width) - 1))
ÂÂ +#define CCLK_SRC_PLLP_OUT0 4
+#define CCLK_SRC_PLLP_OUT4 5
+
ÂÂ static u8 clk_super_get_parent(struct clk_hw *hw)
ÂÂ {
ÂÂÂÂÂÂ struct tegra_clk_super_mux *mux = to_clk_super_mux(hw);
@@ -97,6 +100,14 @@ static int clk_super_set_parent(struct clk_hw
*hw, u8 index)
ÂÂÂÂÂÂÂÂÂÂ if (index == mux->div2_index)
ÂÂÂÂÂÂÂÂÂÂÂÂÂÂ index = mux->pllx_index;
ÂÂÂÂÂÂ }
+
+ÂÂÂ /*
+ÂÂÂÂ * Enable PLLP branches to CPU before selecting PLLP source
+ÂÂÂÂ */
+ÂÂÂ if ((mux->flags & TEGRA_CPU_CLK) &&
+ÂÂÂÂÂÂÂ ((index == CCLK_SRC_PLLP_OUT0) || (index ==
CCLK_SRC_PLLP_OUT4)))
+ÂÂÂÂÂÂÂ tegra_clk_set_pllp_out_cpu(true);
Should somewhere here be tegra_clk_set_pllp_out_cpu(false) when
switching from PLLP?
PLLP may be used for other CPU clusters.
Though to avoid flag and check needed to make sure other CPU is not
using before disabling PLLP branch to CPU.
But leaving it enabled shouldn't impact much as clock source mux is
after this in design anyway.
But can add as well if its clear that way.
The TRM doc says "The CPU subsystem supports a switch-cluster mode
meaning that only one of the clusters can be active at any given time".
Given that cluster-switching isn't supported in upstream, I don't think
that you need to care about the other cluster at all, at least for now.
The cluster-switching implementation in upstream is very complicated
because it requires a special "hotplugging" CPU governor, which
apparently no other platform needs.
[snip]
This patch enables PLLP branches to CPU for both CPUG & CPULP if they
use PLLP source.
So, to disable PLLP out CPU when not in use, we still need check for
other cluster because during resume both LP CPU and G CPU gets restored.
CPUG runs from PLLP on resume and when it does super clk restore for LP
CPU which may not be using PLLP, but as both uses same super mux
clk_ops, without check (for PLLP branch to CPU in use) disabling PLLP
branch to CPU during LP CPU restore looses clock to CPU G as well which
is running from PLLP.
Will add check and disable PLLP if not in use in next version... this
need extern flag as well to mark PLLP usage with either of CPU's.
I still don't understand why do you need to care about LP cluster at
all, given that it's always in a power-gated state.
cclk_lp is registered thru super clk mux which uses same clk_ops as cclk_g.
during restore, cclk_lp also gets restored. So both cclk_lp & cclk_g
goes thru same clk_ops
In this patch, I marked super flags with TEGRA_CPU_CLK for both cclk_lp
& cclk_g.
So when cclk_lp restore happens, it goes thru same set_parent clk_ops
and as its source is not PLLP, it tries to disable PLLP_OUT_CPU if its
disabled without adding check for PLLP being in use by other cluster.
So either I should not mark cclk_lp as TEGRA_CPU_CLK and mark cclk_g
only as TEGRA_CPU_CLK so PLLP out to CPU can be disabled without check
if its not the source.
OR
With TEGRA_CPU_CLK used for both cclk_lp & cclk_g, need to add check if
PLLP is in use so during cclk_lp restore it doesnt disable PLLP out to CPU.
To simplify without check, will just mark cclk_g super clock flag only
as TEGRA_CPU_CLK so PLLP_OUT_CPU enable or disable happens only for CPUG