[PATCH v2 17/18] ARM: dts: qcom: Add PMIC pmx55 dts

[Manivannan Sadhasivam]

From: Vinod Koul <vkoul@xxxxxxxxxx>

This adds DTS for PMIC PMX55 found in Qualcomm platforms.

Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
 arch/arm/boot/dts/qcom-pmx55.dtsi | 91 +++++++++++++++++++++++++++++++
 1 file changed, 91 insertions(+)
 create mode 100644 arch/arm/boot/dts/qcom-pmx55.dtsi

diff --git a/arch/arm/boot/dts/qcom-pmx55.dtsi b/arch/arm/boot/dts/qcom-pmx55.dtsi
new file mode 100644
index 000000000000..05f033334716
--- /dev/null
+++ b/arch/arm/boot/dts/qcom-pmx55.dtsi
@@ -0,0 +1,91 @@
+// SPDX-License-Identifier: BSD-3-Clause
+
+/*
+ * Copyright (c) 2018-2020, The Linux Foundation. All rights reserved.
+ * Copyright (c) 2020, Linaro Limited
+ */
+
+#include <dt-bindings/iio/qcom,spmi-vadc.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+&spmi_bus {
+	pmic@8 {
+		compatible = "qcom,pmx55", "qcom,spmi-pmic";
+		reg = <0x8 SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		power-on@800 {
+			compatible = "qcom,pm8916-pon";
+			reg = <0x0800>;
+
+			status = "disabled";
+		};
+
+		pmx55_temp: temp-alarm@2400 {
+			compatible = "qcom,spmi-temp-alarm";
+			reg = <0x2400>;
+			interrupts = <0x8 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+			io-channels = <&pmx55_adc ADC5_DIE_TEMP>;
+			io-channel-names = "thermal";
+			#thermal-sensor-cells = <0>;
+		};
+
+		pmx55_adc: adc@3100 {
+			compatible = "qcom,spmi-adc5";
+			reg = <0x3100>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			#io-channel-cells = <1>;
+			interrupts = <0x8 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
+
+			ref-gnd@0 {
+				reg = <ADC5_REF_GND>;
+				qcom,pre-scaling = <1 1>;
+				label = "ref_gnd";
+			};
+
+			vref-1p25@1 {
+				reg = <ADC5_1P25VREF>;
+				qcom,pre-scaling = <1 1>;
+				label = "vref_1p25";
+			};
+
+			die-temp@6 {
+				reg = <ADC5_DIE_TEMP>;
+				qcom,pre-scaling = <1 1>;
+				label = "die_temp";
+			};
+
+			chg-temp@9 {
+				reg = <ADC5_CHG_TEMP>;
+				qcom,pre-scaling = <1 1>;
+				label = "chg_temp";
+			};
+		};
+
+		pmx55_gpios: gpio@c000 {
+			compatible = "qcom,pmx55-gpio", "qcom,spmi-gpio";
+			reg = <0xc000>;
+			gpio-controller;
+			#gpio-cells = <2>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+			interrupts = <0x8 0xc0 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc1 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc3 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc4 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc5 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc7 0x0 IRQ_TYPE_NONE>,
+				     <0x8 0xc8 0x0 IRQ_TYPE_NONE>;
+		};
+	};
+
+	pmic@9 {
+		compatible = "qcom,pmx55", "qcom,spmi-pmic";
+		reg = <0x9 SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+	};
+};
-- 
2.25.1